Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Oldcastle Fence Installation: The Woodland Hills Owner’s Guide
Oldcastle fence installation in Woodland Hills typically runs between $3,500 and $9,000 for a complete project, depending on linear footage, terrain, and whether we’re pulling old posts or working with fresh ground. We stock Oldcastle-compatible post caps, panels, gate hardware, and post anchors on our trucks, so most partial failures get fixed in a single visit. The usual discovery happens the hard way: a gate starts dragging on the concrete, a panel leans after a hot Santa Ana wind, or a post base rusts through at the soil line from sprinkler overspray.
Which Oldcastle Models This Applies To
Oldcastle fence systems break into a few families, and the part you need depends on which one is in your yard. The biggest compatibility gotcha we see in Woodland Hills is post sizing: older Oldcastle ornamental steel panels seat into 2-inch square posts, while the newer architectural series uses 2.25-inch posts with internal brackets. If you order a panel for the wrong post size, it won’t seat, period. Find the label: most Oldcastle posts have a stamped code near the base plate or inside the post cap channel. If that’s faded out, measure the post’s outside dimension with a tape, and check the panel’s tab spacing where it locks into the rail. For gates, Oldcastle uses two hinge patterns: a bolted strap hinge on the classic series and a welded barrel hinge on the architectural line. We keep both on the truck, along with OEM spec posts and a quality aftermarket equivalent for common panel sizes. The aftermarket panels we carry are gauge-matched to Oldcastle’s original spec, but if you want the exact finish match on a 10-year-old fence, OEM is the safer call because powder coat fades differently by batch.
Styles & brands we work with
Signs Your Oldcastle Fence Installation Is Failing
- Leaning posts near sprinkler heads. This is the number one Woodland Hills failure. Constant moisture at the soil line eats through the post’s galvanized coating, then rust takes over. The post can look perfect at eye level and be paper-thin underground.
- Gate dragging or won’t latch. Most of the time the hinge bolts have chewed through the post wall, or the post itself has shifted. Tightening only buys a few weeks; once the hole wallows out, the post needs a sleeve or full replacement.
- Panels rattling in wind. Oldcastle panels lock into routed channels in the post. When the internal plastic shims crack from UV, the panel has room to move. It’s a cheap fix if you catch it before the panel edge galls the aluminum.
- Post cap missing or split. Water gets straight into the hollow post. In a place where we get real rain a few months a year, a missing cap turns into a rust column from the inside out.
- White powdery bloom on aluminum components. That’s oxidation breaking through a compromised powder coat. Cosmetic now, structural in a few seasons once the raw aluminum pits.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Woodland Hills, you should budget $3,500 to $9,000 for a full Oldcastle fence installation. Per linear foot, that shakes out to roughly $55 to $90 depending on style, post depth, and access. A partial repair, like swapping three posts and re-hanging a gate, lands in the $600 to $1,800 range. The wide spread comes from a few things: hillside lots with slope steps, soil conditions (some Woodland Hills yards sit on decomposed granite that eats drill bits), and whether the old concrete footings need to be jackhammered out or can be re-used. We put the price in writing before any work starts, and the number on the invoice is the number you approved. Every Oldcastle fence installation we do carries the 365-Day Done Right Promise: if it’s not installed right, we make it right within a full year.
DIY or Call Us?
You can safely check your post caps, measure your post dimensions, and identify the panel series using the label or stamp on the post. That’s all worth doing before you call so we can pack the right parts the first time. What I’d caution against is digging around base plates on a hillside fence: if you undermine the footing and a post lets go, you’re talking about a couple hundred pounds of steel panel coming down. Call (341) 217-2776 and we’ll handle the heavy part. If you describe what you’re seeing, we’ll usually tell you over the phone whether it looks like a post swap, a panel replacement, or a full run.
FAQs
Expect 12 to 18 years from the posts, with panels often lasting longer. Woodland Hills sprinkler systems and summer heat shorten the post lifespan compared to inland areas with drier soil.
Sometimes. If the post is sound above ground but rusted at the soil line, we can install a galvanized sleeve and re-anchor the base, which costs less than a full post replacement. If the steel is compromised through-and-through, it’s a swap. Call (341) 217-2776 and we’ll assess it in person.
Most single-part repairs, like a post or gate hinge, are done in one visit once we’ve seen the part. Full fence installations usually run two to four working days depending on the linear footage and footing conditions.
We stock the common parts on our trucks: post caps, gate hinges, panel shims, and standard panel sizes. If your Oldcastle fence is an older or less common series, we order the OEM part and you’ll have a firm lead time before we schedule.
Need an exact quote on your Oldcastle fence installation in Woodland Hills? Call (341) 217-2776 and we’ll give you a written price before any work starts. Free estimates, no surprises.
Written by Luca Romano, Owner, Sawyer Remodel Woodland Hills at Sawyer Remodel Woodland Hills, serving Woodland Hills and nearby areas.
